CHEVRON ENVIRONMENTAL HEALTH CENTER, INC. -- ORTHO PRUNING SEALER  -- 6850-00B030070
<pre>=====================  Product Identification  =====================

Product ID:ORTHO PRUNING SEALER
MSDS Date:01/01/1987
FSC:6850
NIIN:00B030070
=== Responsible Party ===
Company Name:CHEVRON ENVIRONMENTAL HEALTH CENTER, INC.
Box:4054
City:RICHMOND
State:CA
ZIP:94804-0054
Country:US
Info Phone Num:415-233-3737
Emergency Phone Num:415-233-3737
CAGE:0AHD1
=== Contractor Identification ===
Company Name:CHEVRON ENVIRONMENTAL HEALTH CENTER INC
Address:15299 SAN PABLO AVE
Box:4054
City:RICHMOND
State:CA
ZIP:94804
Country:US
Phone:800-582-3835
CAGE:0AHD1

=============  Composition/Information on Ingredients  =============

Ingred Name:ASPHALT (PETROLEUM)
CAS:8052-42-4
RTECS #:CI9900000
Fraction by Wt: 30%
ACGIH TLV:5 MG/M3; (FUME);9192

Ingred Name:STODDARD SOLVENT
CAS:8052-41-3
RTECS #:WJ8925000
Fraction by Wt: 30%
OSHA PEL:500 PPM
ACGIH TLV:100 PPM; 9293

Ingred Name:METHYLENE CHLORIDE	(SARA III)
CAS:75-09-2
RTECS #:PA8050000
Fraction by Wt: 25%
OSHA PEL:500 PPM/C,1000; Z2
ACGIH TLV:50 PPM, A2; 9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:PROPANE
CAS:74-98-6
RTECS #:TX2275000
Fraction by Wt: 15%
OSHA PEL:1000 PPM
ACGIH TLV:ASPHYXIANT; 9192

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:UNKNOWN	  IARC:NO
Health Hazards Acute and Chronic:NOT EXPECTED TO BE ACUTELY TOXIC BY
    INHALATION OR INGESTION. THE ACUTE ORAL LD50 (RAT) WAS GREATER THAN
    15 G/KG.

=======================  First Aid Measures  =======================

First Aid:EYES-FLUSH EYES IMMEDIATELY WITH FRESH WATER FOR AT LEAST 15
    MIN. SKIN-REMOVE CONTAMINATED CLOTHING. INHALATION-SINCE THIS
    MATERIAL IS NOT EXPECTED TO BE AN ACUTE INHALATION PROBLEM, NO
    FIRST AID PROC EDURES ARE REQUIRED. INGESTION-IF SWALLOWED, GIVE
    WATER OR MILK TO DRINK AND TELEPHONE FOR MEDICAL ADVICE.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TOC
Flash Point:100.0F,37.8C
Lower Limits:NDA
Upper Limits:NDA
Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER FOG.
Fire Fighting Procedures:FOR FIRES INVOLVING THIS MATERIAL, DO NOT
    ENTER ANY ENCLOSED OR CONFINED FIRE SPACE W/O PROPER PROTECTIVE
    EQUIPMENT, INCLUDING SELF-CONTAINED BREATHING APPARATU

==================  Accidental Release Measures  ==================

Spill Release Procedures:ELIMINATE ALL SOURCES OF IGNITION IN VICINITY
    OF SPILL OR RELEASED VAPOR. CLEAN UP SPILLS IMMEDIATELY, OBSERVING
    PRECAUTIONS IN SPECIAL PROTECTIVE INFORMATION.  COVER SPILL WITH A
    GENEROUS AMOUNT OF O IL DRY, CAT LITTER, CLAY, RAGS OR
    OTHERABSORBENT.

======================	Handling and Storage  ======================

Handling and Storage Precautions:DO NOT USE OR STORE NEAR FLAME, SPARKS
    OR HOT SURFACES. USE ONLY IN WELL VENTILATED AREA. KEEP CONTAINERS
    CLOSED.
Other Precautions:DO NOT WELD, HEAT OR DRILL CONTAINER. REPLACE CAP OR
    BUNG. EMPTIED CONTAINER STILL CONTAINS HAZARDOUS OR EXPLOSIVE VAPOR
    OR LIQUID.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NO SPECIAL RESPIRATORY PROTECTION IS NORMALLY
    REQUIRED. HOWEVER, IF OPERATING CONDITIONS CREATE AIRBORNE
    CONCENTRATIONS WHICH EXCEED THE EXPOSURE STANDARDS, THE USE OF AN
    APPROVED RESPIRATORY IS RECOM MENDED.
Ventilation:USE ADEQUATE VENTILATION TO KEEP THE AIRBORNE
    CONCENTRATIONS OF THIS MATERIAL BELOW THE EXP0SURE STANDARDS.
Protective Gloves:IMPERVIOUS PROTECTIVE GLOVES
Eye Protection:CHEMICAL SAFETY GOGGLES
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Vapor Pres:NDA
Vapor Density:NDA
Spec Gravity:.96 @ 20/20 C
Evaporation Rate &amp; Reference:NO DATA AVAILABLE (NDA)
Solubility in Water:INSOLUBLE IN WATER
Appearance and Odor:THICK BLACK LIQUID
Percent Volatiles by Volume:NDA

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
MAY REACT WITH STRONG OXIDIZING MATERIALS.
Hazardous Decomposition Products:NORMAL COMBUSTION FORMS CARBON DIOXIDE
    & WATER VAPOR AND MAY PRODUCE OXIDES OF SULFUR & TOXIC CHLORINE
    COMPOUNDS;
Conditions to Avoid Polymerization:INCOMPLETE COMBUSTION CAN PRODUCE
    CARBON MONOXIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:PLACE CONTAMINATED MATERIALS IN DISPOSABLE
    CONTAINERS AND DISPOSE OF IN A MANNER CONSISTENT WITH APPLICABLE
    REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.